CM-7002 Screenable Mask

 

CM-7002 is a water based screenable mask which provides a protective film overlay on pre-printed and/or finished parts to protect them from scratches and other abrasive stress during subsequent handling and shipping. After the mask had dried, it can be then be easily removed/peeled from the substrate.

 
 

Screenable Mask

 
Clear CM-7002
Blue Tint Additive CM-38973

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

QT CMK Rev A


Substrates
 

Coated metals, Aluminum, Glass

 

Modification
 

Generally none required.

 

Drying
CM-7002 dries by evaporation. We recommend drying the mask using forced air at 120 °F for approximately 30 seconds. Note: Actual drying time will be dependent upon film deposition, air volume, movement and impingement on the printed part.
 

Stencils

Water resistant emulsions/films.

 

Screen Mesh

50 to 110 TPI monofilament fabrics.

 

Squeegee

60 to 70 durometer.

 

Wash-Up

Warm Water

 

Product Range

CM-7002 Clear - dries to a hazy translucent finish

CM-38973 Blue Tint Additive (for contrast)

 

 

 

Note: Information contained in Cudner & O'Connor printed matter is based on laboratory and field tests. Because we cannot control actual production conditions, no warranty is expressed or implied. Careful testing is always recommended prior to production. Consult our Technical Service Department on all application issues.

CANDOC is a trademark of Cudner & O'Connor Company. All other products mentioned are registered trademarks or trademarks of their respective companies.

Questions or problems regarding this website should be directed to info@candocinks.com.
Copyright © 2001 Cudner & O'Connor Company. All rights reserved.
Last modified: Tuesday June 25, 2007 .